|
| |
| Antique Tractor Pictures - Parts and Pieces |
49 DC Case - Brake Cross Section
[Return to Photos]
|
|
| Here is a cross section of a 40s vintage DC Case brake. Several things are noteworthy for adjusting endplay in the shaft 1. Looking at the differential in the middle, there is no thrust bearing between the big drive gear and the two spider gear on the shaft. Thus, a high preload should be avoided. Shoot for no preload and no endplay. 2. Each side has a shim pack. I would adjust on the side with the thickest shim pack if there is an obvious difference in thickness. However, both the big gear and the chain drives are tolerant of some side to side misalignment so no need for the two shim packs to be exactly the same thickness. 3. To do the adjustment, I completely remove one shim pack and first assemble the bearing support without the shim pack. Uniformly snug up the bolts to about 5 to 10 percent tight. Using a feeler gage, check the gap where shims belong at about 3 or 4 places around. Tweak the bolts until the gap is even all around. If there is no gap, shims will also have to be taken out of the other side. 4. At the same time the bolts are being snugged up and also to do the job right, both bearings on the shaft should be rotated a little. This allows all rollers within the two tapered roller bearing to move into their running position which is against the flange on the inner race of the bearing. Unfortunately, both rear tires need to be off the ground to do this because turning each tire rotates only one of the tapered roller bearings While turning a tire with the bolts snugged, one can put their ear to the roller bearing and listen for any roughness within the bearing. 5. Install a shim pack that is the thickness of the gap. |
Submitted By: Ron Sa from IL
[ Add a Comment ] [ View Comments (0) ] |
[ Return to Photos]
Home
| Forums
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|
